zbMATH — the first resource for mathematics

Investigations on the influence of swirl intensity on solid-fuel ramjet engine. (English) Zbl 1390.80020
Summary: In this paper, the influence of swirl intensity on solid fuel regression rate and combustion phenomena in a solid fuel ramjet has been investigated numerically and experimentally. First, an in-house code has been developed to solve axisymmetric Reynolds-averaged Navier-Stokes equations of unsteady turbulent swirling compressible flow field with chemical reactions. Second, experiments have been conducted in a solid fuel ramjet without swirl to validate the developed code for solid fuel decomposition; then the predictive capability of the code is validated by using; swirling flow passes through sudden expansion combustor, shock-induced combustion case, and a semi-infinite plate. Third, unsteady simulations are carried out for reacting turbulent flows with and without swirl in a solid fuel ramjet using high-density polyethylene (HDPE) solid fuel. Then, the computational results are analyzed and discussed. The results show that, the presence of swirl is more effective in enhancing the regression rate and the turbulent mixing throughout the ramjet. Increase swirl number increases the heat and mass transport at the fuel surface and hence increases the regression rate.
80M12 Finite volume methods applied to problems in thermodynamics and heat transfer
65M08 Finite volume methods for initial value and initial-boundary value problems involving PDEs
80A25 Combustion
Full Text: DOI
[1] Duesterhaus, D.; Hogl, A., Measurements in a solid fuel ramjet combustion with swirl, AIAA paper, 88-3045, (1988)
[2] Krishnan, S.; George, P., Solid fuel ramjet combustor design, Prog Aerosp Sci, 34, 3, 219-256, (1998)
[3] Korting, P.; Van Der Geld, C.; Wijchers, T.; Schoyer, H., Combustion of polymethylmethacrylate in a solid fuel ramjet, J Propul Power, 6, 3, 263-270, (1990)
[4] Levy, Y.; Gany, A.; Zvuloni, R., Investigation of a small solid fuel ramjet combustor, J Propul Power, 5, 3, 269-275, (1989)
[5] Schulte, G., Fuel regression and flame stabilization studies of solid-fuel ramjets, J Propul Power, 2, 4, 301-304, (1986)
[6] Netzer, D. W., Modeling solid-fuel ramjet combustion, J Spacecr Rockets, 14, 12, 762-766, (1977)
[7] Li, Y.; Li, R.; Li, D.; Bao, J.; Zhang, P., Combustion characteristics of a slotted swirl combustor: an experimental test and numerical validation, Int Commun Heat Mass Transfer, 66, 140-147, (2015)
[8] Tahsini, A., Ignition delay time in swirling supersonic flow, Acta Astronaut, 83, 91-96, (2013)
[9] Jing, J.; Li, Z.; Zhu, Q.; Chen, Z.; Wang, L.; Chen, L., Influence of the outer secondary air vane angle on the gas/particle flow characteristics near the double swirl flow burner region, Energy, 36, 1, 258-267, (2011)
[10] Gassoumi, T.; Guedri, K.; Said, R., Numerical study of the swirl effect on a coaxial jet combustor flame including radiative heat transfer, Numer Heat Transfer, Part A, 56, 11, 897-913, (2009)
[11] Nemoda, S.; Bakić, V.; Oka, S.; Zivković, G.; Crnomarković, N., Experimental and numerical investigation of gaseous fuel combustion in swirl chamber, Int J Heat Mass Transf, 48, 21, 4623-4632, (2005)
[12] Lilley, D.; SAMPLES, J.; RHODE, D., Prediction of swirling reacting flow in ramjet combustors, AIAA, SAE, and ASME, 17th joint propulsion conference, Colorado Springs,, (1981)
[13] Liu, Y.; Tang, H.; Tian, Z.; Zheng, H., Cfd simulations of turbulent flows in a twin swirl combustor by rans and hybrid rans/LES methods, Energy Procedia, 66, 329-332, (2015)
[14] Al-Abdeli, Y. M.; Masri, A. R., Review of laboratory swirl burners and experiments for model validation, Exp Therm Fluid Sci, 69, 178-196, (2015)
[15] Ranga Dinesh, K.; Jenkins, K. W.; Kirkpatrick, M.; Malalasekera, W., Effects of swirl on intermittency characteristics in non-premixed flames, Combust Sci Technol, 184, 5, 629-659, (2012)
[16] Ramírez, J. A.; Cortés, C.; Carrión, A.; Carmona, M.; Legrand, M., Prediction of flow instabilities in an atmospheric low swirl burner using urans models, Numer Heat Transfer, Part A, 62, 6, 479-498, (2012)
[17] Zhang, J.; Zhu, C., Simulation of swirling turbulent flow and combustion in a combustor, Numer Heat Transfer, Part A, 55, 5, 448-464, (2009)
[18] Zhang, J.; Chen, C., Simulation of turbulent reacting flow in a swirl combustor, Numer Heat Transfer, Part A, 53, 6, 605-624, (2007)
[19] Zhang, J.; Dong, L.; Zhou, L.; Nieh, S., Simulation of swirling turbulent flows and heat transfer in an annular duct, Numer Heat Transfer, Part A, 44, 6, 591-609, (2003)
[20] Kim, Y.; Shang, H.; Chen, C.; Wang, T., Prediction of confined swirling spray-combusting flows, Numer Heat Transfer, Part A, 25, 1, 1-19, (1994)
[21] From, C.; Sauret, E.; Armfield, S.; Saha, S.; Gu, Y., Turbulent dense gas flow characteristics in swirling conical diffuser, Comput Fluids, 149, 100-118, (2017) · Zbl 1390.76432
[22] Ahmed, Z. U.; Al-Abdeli, Y. M.; Matthews, M. T., The effect of inflow conditions on the development of non-swirling versus swirling impinging turbulent jets, Comput Fluids, 118, 255-273, (2015)
[23] Xia, J.; Smith, B.; Benim, A.; Schmidli, J.; Yadigaroglu, G., Effect of inlet and outlet boundary conditions on swirling flows, Comput fluids, 26, 8, 811-823, (1997) · Zbl 0900.76711
[24] Pein, R.; Vinnemeier, F., Swirl and fuel composition effects on boron combustion in solid-fuelramjets, J Propul Power, 8, 3, 609-614, (1992)
[25] Campbell Jr, W. H., An experimental investigation of the effects of swirling air flows on the combustion properties of a solid fuel ramjet motor, Report, (1985), DTIC Document
[26] Kee R.J., Rupley F.M., Meeks E., Miller J.A., Chemkin-III A. A fortran chemical kinetics package for the analysis of gas phase chemical and plasma kinetics. Sandia National Laboratories1996;.
[27] Baurle, R.; Mathur, T.; Gruber, M.; Jackson, K., A numerical and experimental investigation of a scramjet combustor for hypersonic missile applications, AIAA Paper, 3121, 1998, (1998)
[28] Brindle, A.; Boyce, R. R.; Neely, A. J., Cfd analysis of an ethylene-fueled intake-injection shock-induced-combustion scramjet configuration, AIAA/CIRA 13th international space planes and hypersonic systems and technologies, AIAA Paper 2005, 3239, (2005)
[29] Mawid, M.; Sekar, B., Kinetic modeling of ethylene oxidation in high speed reacting flows, AIAA Paper, 3269, (1997)
[30] Giles, M. B., Nonreflecting boundary conditions for Euler equation calculations, AIAA J, 28, 2050-2058, (1990)
[31] Holmes, D. G., Inviscid 2d solutions on unstructured, adaptive grids, VKI Numer Methods Flows Turbomach, 1, 8, (1989)
[32] Nilsson, H., Simulations of the vortex in the dellenback abrupt expansion, resembling a hydro turbine draft tube operating at part-load, IOP conference series: earth and environmental science, 15, 022016, (2012), IOP Publishing
[33] Kim, K. H.; Kim, C.; Rho, O.-H., Methods for the accurate computations of hypersonic flows: I. ausmpw+ scheme, J Comput Phys, 174, 1, 38-80, (2001) · Zbl 1106.76421
[34] Van Leer, B., Towards the ultimate conservative difference scheme. V. A second-order sequel to godunov’s method, J Comput Phys, 32, 1, 101-136, (1979) · Zbl 1364.65223
[35] Van Albada, G.; Van Leer, B.; Roberts Jr, W., A comparative study of computational methods in cosmic gas dynamics, Astron Astrophys, 108, 76-84, (1982) · Zbl 0492.76117
[36] Menter, F. R., Two-equation eddy-viscosity turbulence models for engineering applications, AIAA J, 32, 8, 1598-1605, (1994)
[37] Zhang, L.; Wang, Z., A block Lu-sgs implicit dual time-stepping algorithm for hybrid dynamic meshes, Comput fluids, 33, 7, 891-916, (2004) · Zbl 1070.76038
[38] Musa, O.; Changsheng, Z.; Xiong, C.; Lunkun, G., Prediction of swirling cold flow in a solid-fuel ramjet engine with a modified rotation/curvature correction sst turbulence model, Appl Therm Eng, 105, 737-754, (2016)
[39] Musa, O.; Changshen, Z.; Xiong, C.; Yingkun, L., Verification study of a cfd-rans code for turbulent flow at high Reynolds numbers, Int J Model Optim, 6, 1, 1-10, (2016)
[40] Musa, O.; Xiong, C.; Changsheng, Z.; Li, W., Effect of inlet conditions on swirling turbulent reacting flows in a solid fuel ramjet engine, Appl Therm Eng, 113, 186-207, (2017)
[41] Dellenback, P.; Metzger, D.; NEITZEL, G., Measurements in turbulent swirling flow through an abrupt axisymmetric expansion, AIAA J, 26, 6, 669-681, (1988)
[42] Hoffman, J. D.; Thompson, H. D.; MARCUM, D. L., Analytical study of swirler effects in annular propulsive nozzles, J Propul Power, 3, 5, 465-466, (1987)
[43] Dutton, J., Swirling supersonic nozzle flow, J Propul Power, 3, 4, 342-349, (1987)
This reference list is based on information provided by the publisher or from digital mathematics libraries. Its items are heuristically matched to zbMATH identifiers and may contain data conversion errors. It attempts to reflect the references listed in the original paper as accurately as possible without claiming the completeness or perfect precision of the matching.