×

zbMATH — the first resource for mathematics

Turbulent dense gas flow characteristics in swirling conical diffuser. (English) Zbl 1390.76432
Summary: Diffusers placed at the exit of turbines are essential to recover pressure and increase turbine efficiency. This increase of efficiency is critical for the overall cycle efficiency of renewable power cycles based on low temperature renewable resources. Optimising the performance of a conical diffuser in renewable power cycles using high-density fluids can be established by examining the turbulence characteristics of both air considered as an ideal gas (IG) and R143a, a refrigerant with high-density in a non-ideal state, considered as a real gas (RG). Turbulence was firstly modelled and validated against experimental results from the ERCOFTAC swirling conical diffuser database and previous numerical results. The real gas thermodynamic and transport properties of refrigerant R143a were then obtained from the NIST REFPROP database. Investigating both RG and IG revealed that general trends remain, where the stronger wall components in RG help improve the diffuser performance. Furthermore, investigations regarding turbulence intensities indicated a clear effect on the flow behaviour for IG while being ineffective on the RG. The final application analysed the diffuser performance using the inlet conditions extracted directly from a potential radial-inflow turbine working with R143a. The change of conditions highlighted that radial components can be reduced, and thus the swirling number, too. By implementing the first numerical study on real gas swirling conical diffuser, it was established that real gas flow regimes differ from the ones previously established for ideal gas, and thus, preliminary flow regimes for R143a, specifically, are proposed.

MSC:
76M12 Finite volume methods applied to problems in fluid mechanics
65M08 Finite volume methods for initial value and initial-boundary value problems involving PDEs
76N15 Gas dynamics, general
76V05 Reaction effects in flows
76F60 \(k\)-\(\varepsilon\) modeling in turbulence
Software:
Refprop
PDF BibTeX XML Cite
Full Text: DOI
References:
[1] Armfield, S. W.; Cho, C.-H.; Fletcher, C. A.J., Prediction of turbulence quantities for swirling flow in conical diffusers, AIAA J, 28, 453-460, (1990)
[2] Armfield, S. W.; Fletcher, C. A.J., Numerical simulation of swirling flow in diffusers, Int J Numer Methods Fluids, 6, 8, 541-556, (1986) · Zbl 0597.76025
[3] Armfield, S. W.; Fletcher, C. A.J., Comparison of k-epsilon and algebraic Reynolds stress models for swirling diffuser flow, Int J Numer Methods Fluids, 9, 987-1009, (1989)
[4] Azad, R. S., Turbulent flow in a conical diffuser: a review, Exp Therm Fluid Sci, 13, 318-337, (1996)
[5] Azad, R. S.; Kassab, S. Z., Turbulent flow in a conical diffuser: overview and implications, Phys Fluids A, 1, 564-573, (1989) · Zbl 1222.76001
[6] Barth, T.; Jespersen, D., The design and application of upwind schemes on unstructured meshes, (1989), Aerospace Sciences Meetings; American Institute of Aeronautics and Astronautics
[7] Batchelor, G. K., An introduction to fluid dynamics:, (2000), Cambridge Mathematical Library; Cambridge University Press · Zbl 0958.76001
[8] Bounous, O., Studies of the ercoftac conical diffuser with openfoam, Tech. Rep., (2008), Division of Fluid Dynamics, Department of Applied Mechanics, Chalmers University of Technology, Göteborg, Sweden
[9] Bragg, S. L.; Hawthorne, W. R., Some exact solutions of the flow through annular cascade actuator discs, J Aeronaut Sci, 17, 4, 243-249, (1950)
[10] Cho, C.-H.; Fletcher, C. A.J., Computation of turbulent conical diffuser flows using a non-orthogonal grid system, Comput Fluids, 19, 347-361, (1991)
[11] Cho, N.-H., Computation of turbulent swirling flows in conical diffusers with tailpipes. Ph.D. thesis, (1990), Department of Mechanical Engineering, The University of Sydney
[12] Cinnella, P.; Congedo, P. M., Numerical solver for dense gas flows, AIAA J, 43, 11, 2458-2461, (2005)
[13] Cinnella, P.; Congedo, P. M., Inviscid and viscous aerodynamics of dense gases, J Fluid Mech, 580, 179-217, (2007) · Zbl 1113.76046
[14] Clausen, P.; Koh, S.; Wood, D., Measurements of a swirling turbulent boundary layer developing in a conical diffuser, Exp Therm Fluid Sci, 6, 39-48, (1993)
[15] Clausen, P.; Wood, D., Some measurements of swirling flow through an axisymmetric diffuser, Proceedings of 6th Symposium on Turbulent Shear Flows, Toulouse, France, (1987)
[16] Congedo, P.; Corre, C.; Cinnella, P., Numerical investigation of dense-gas effects in turbomachinery, Comput Fluids, 49, 1, 290-301, (2011) · Zbl 1271.76291
[17] Duprat, C., Simulation numérique instationnaire des écoulements turbulents dans les diffuseurs des turbines hydrauliques en vue de l’amélioration des performances. Ph.D. thesis, (2010), Laboratoire des Ecoulements Géophysiques et Industriels (LEGI, UMR 5519, CNRS-UJF-INPG), Université de Grenoble, France
[18] Gatski, T. B.; Speziale, C. G., On explicit algebraic stress models for complex turbulent model, J Fluid Mech, 254, 59-78, (1993) · Zbl 0781.76052
[19] Gyllenram, W.; Nilsson, H., Very large eddy simulation of draft tube flow, 23rd IAHR Symposium, Yokohama, Japan, (2006)
[20] Jakirlić, S.; Hanjalić, K.; Tropea, C., Modeling rotating and swirling turbulent flows: a perpetual challenge, AIAA J, 40, 1984-1996, (2002)
[21] Jeyachandran, K.; Ganesan, V., Numerical modelling of turbulent flow through conical diffusers with uniform and wake velocity profiles at the inlet, Math Comput Model, 10, 2, 87-97, (1988) · Zbl 0639.76066
[22] Klein, A., Review: effects of inlet conditions on conical-diffuser performance, J Fluids Eng, 103, 250-257, (1981)
[23] Klonowicz, P.; Borsukiewicz-Gozdur, A.; Hanausek, P.; Kryllowicz, W.; Bruggemann, D., Design and performance measurements of an organic vapour turbine, Appl Therm Eng, 63, 297-303, (2014)
[24] Kluwick, A.; Meyer, G., Shock regularization in dense gases by viscousâ;;inviscid interactions, J Fluid Mech, 644, 473-507, (2010) · Zbl 1189.76332
[25] Launder, B. E.; Reece, G. J.; Rodi, W., Progress in the development of a Reynolds-stress turbulence closure, J Fluid Mech, 68, 537-566, (1975) · Zbl 0301.76030
[26] Lee J., Jang S.J., Sung H.J.. Direct numerical simulations of turbulent flow in a conical diffuser. J Turbul 13, N30. · Zbl 1273.76207
[27] Lemmon, E. W.; Huber, M. L.; McLinden, M. O., NIST reference fluid thermodynamic and transport properties-REFPROP, version 8.0, Tech. Rep., (2007), Physical and Chemical Properties Division, National Institute of Standards and Technology
[28] Lemmon, W. W.; Jacobsen, R. T., An international standard formulation for the thermodynamic properties of 1,1,1-trifluoroethane (hfc-143a) for temperatures from 161 to 450 k and pressures to 50 mpa., J Phys Chem Ref Data, 29 (4), 521-552, (2000)
[29] Maicke, B.; Majdalani, J., On the compressible bidirectional vortex. part 1: a Bragg-Hawthorne stream function formulation, 50th AIAA Aerospace Sciences Meeting including the New Horizons Forum and Aerospace Exposition, 1103, (2012)
[30] Maicke, B.; Majdalani, J., On the compressible bidirectional vortex. part 2: a Beltramian flowfield approximation, 50th AIAA Aerospace Sciences Meeting including the New Horizons Forum and Aerospace Exposition, 1104, (2012)
[31] McDonald, A. T.; Fox, R. W.; Van Dewoestine, R. V., Effects of swirling inlet flow on pressure recovery in conical diffusers, AIAA J, 9, 2014-2018, (1971)
[32] Menter, F.; Garbaruk, A.; Egorov, Y., Explicit algebraic Reynolds stress models for anisotropic wall-bounded flows, EUCASS Proc Ser, 3, 89-104, (2012)
[33] Menter, F. R., Two equation eddy-viscosity turbulence models for engineering applications, AIAA J, 32, No. 8, 1598-1605, (1994)
[34] Merle, X.; Cinnella, P., Bayesian quantification of thermodynamic uncertainties in dense gas flows, Reliab Eng Syst Saf, 134, 305-323, (2015)
[35] Okwuobi, P. A.C.; Azad, R. S., Turbulence in a conical diffuser with fully developed flow at entry, J Fluid Mech, 57, 603-622, (1973)
[36] Payette, F.-A., Simulation de l’écoulement turbulent dans les aspirateurs de turbines hydrauliques : Impact des paramètres de modélisation. Master’s thesis, (2008), Faculté des Sciences et de Génie, Université de Laval, Québec
[37] Persky, R.; Sauret, E.; Ma, L., Optimisation methods for coupled thermodynamic and 1D design of radial-inflow turbines, Proceedings of the ASME 2014 Joint US-European Fluids Engineering, Division Summer Meeting and 11th International Conference on Nanochannels, Microchannels, and Minichannels, FEDSM 2014, August 3-7, 2014, Chicago, Illinois, USA, (2014)
[38] Peters, H., Energieumsetzung in querschnittserweiterungen bei verschiedenen zulaufbedingungen, Ingenieur-Archiv, 2, 1, 92-107, (1931) · JFM 57.1114.03
[39] Pini, M.; Persico, G.; Casati, E.; Dossena, V., Preliminary design of a centrifugal turbine for organic rankine cycle applications, J Eng Gas Turbine Power, 135, 042312-1-042312-9, (2013)
[40] Pope, S. B., A more general effective-viscosity hypothesis, J Fluid Mech, 72, 331-340, (1975) · Zbl 0315.76024
[41] Pordal, H.; Khosla, P.; Rubin, S., Pressure flux-split viscous solutions for swirl diffusers, Comput Fluids, 22, 4-5, 663-683, (1993) · Zbl 0780.76053
[42] Rhie, C.; Chow, W., Numerical study of the turbulent flow past an airfoil with trailing edge separation, AIAA J, 21, 11, 1525-1532, (1983) · Zbl 0528.76044
[43] Rotta, J. C., Statistische theorie nichthomogener turbulenz, J Fluid Mech, 129, 547-572, (1951) · Zbl 0042.43304
[44] Sauret, E.; Gu, Y., Three-dimensional off-design numerical analysis of an organic rankine cycle radial-inflow turbine, Appl Energy, 135, 202-211, (2014)
[45] Sauret, E.; Persky, R.; Chassaing, J.-C.; Lucor, D., Uncertainty quantification applied to the performance analysis of a conical diffuser, 19th Australasian Fluid Mechanics Conference, Melbourne, Australia, 8-11 December, (2014)
[46] Sauret, E.; Rowlands, A. S., Candidate radial-inflow turbines and high-density working fluids for geothermal power systems, Energy, 36, 4460-4467, (2011)
[47] Senoo, Y.; Kawaguchi, N.; Nagata, T., Swirl flow in conical diffusers, Bull Japan Soc Mech Eng JSME, 21, 112-119, (1978)
[48] Senoo, Y.; Nishi, M., Improvement of the performance of conical diffusers by vortex generators, J Fluids Eng, 96, 1, 4, (1974)
[49] Wallin, S.; Johansson, A. V., An explicit algebraic Reynolds stress model for incompressible and compressible turbulent flows, J Fluid Mech, 403, 89-132, (2000) · Zbl 0966.76032
[50] Wheeler, A. P.S.; Ong, J., The role of dense gas dynamics on organic rankine cycle turbine performance, J Eng Gas Turbines Powerngineering, 135, 102603-1-102603-9, (2013)
[51] Wilcox, D., Turbulence modelimg for cfd, (2006), DCW Industries
[52] Wu, X.; Schlüter, J.; Moin, P.; Pitsch, H.; Iaccarino, G.; Ham, F., Computational study on the internal layer in a diffuser, J Fluid Mech, 550, 391-412, (2006) · Zbl 1222.76062
This reference list is based on information provided by the publisher or from digital mathematics libraries. Its items are heuristically matched to zbMATH identifiers and may contain data conversion errors. It attempts to reflect the references listed in the original paper as accurately as possible without claiming the completeness or perfect precision of the matching.