×

Second-mode attenuation and cancellation by porous coatings in a high-speed boundary layer. (English) Zbl 1287.76191

Summary: Numerical simulations of the linear and nonlinear two-dimensional Navier-Stokes equations, and linear stability theory are used to parametrically investigate hypersonic boundary layers over ultrasonic absorptive coatings. The porous coatings consist of a uniform array of rectangular pores (slots) with a range of porosities and pore aspect ratios. For the numerical simulations, temporally (rather than spatially) evolving boundary layers are considered and we provide evidence that this approximation is appropriate for slowly growing second-mode instabilities. We consider coatings operating in the typical regime where the pores are relatively deep and acoustic waves and second-mode instabilities are attenuated by viscous effects inside the pores, as well as regimes with phase cancellation or reinforcement associated with reflection of acoustic waves from the bottom of the pores. These conditions are defined as attenuative and cancellation/reinforcement regimes, respectively. The focus of the present study is on the cases which have not been systematically studied in the past, namely the reinforcement regime (which represents a worst-case scenario, i.e. minimal second-mode damping) and the cancellation regime (which corresponds to the configuration with the most potential improvement). For all but one of the cases considered, the linear simulations show good agreement with the results of linear instability theory that employs an approximate porous-wall boundary condition, and confirm that the porous coating stabilizing performance is directly related to their acoustic scattering performance. A particular case with relatively shallow pores and very high porosity showed the existence of a shorter-wavelength instability that was not initially predicted by theory. Our analysis shows that this new mode is associated with acoustic resonances in the pores and can be more unstable than the second mode. Modifications to the theoretical model are suggested to account for the new mode and to provide estimates of the porous coating parameters that avoid this detrimental instability. Finally, nonlinear simulations confirm the conclusions of the linear analysis; in particular, we did not observe any tripping of the boundary layer by small-scale disturbances associated with individual pores.

MSC:

76N25 Flow control and optimization for compressible fluids and gas dynamics
76N20 Boundary-layer theory for compressible fluids and gas dynamics
76K05 Hypersonic flows
76S05 Flows in porous media; filtration; seepage
76E05 Parallel shear flows in hydrodynamic stability
PDFBibTeX XMLCite
Full Text: DOI Link

References:

[1] DOI: 10.1016/0021-9991(92)90324-R · Zbl 0759.65006 · doi:10.1016/0021-9991(92)90324-R
[2] Part B. Doc. 900-277 (1969)
[3] DOI: 10.1016/0021-9991(90)90152-Q · Zbl 0701.76070 · doi:10.1016/0021-9991(90)90152-Q
[4] Boundary Layer Theory (2000)
[5] DOI: 10.2514/3.49694 · doi:10.2514/3.49694
[6] DOI: 10.1017/S0022112062001184 · Zbl 0108.20503 · doi:10.1017/S0022112062001184
[7] DOI: 10.2514/2.167 · Zbl 0903.76081 · doi:10.2514/2.167
[8] DOI: 10.1063/1.3481147 · Zbl 06421101 · doi:10.1063/1.3481147
[9] DOI: 10.2514/1.J050835 · doi:10.2514/1.J050835
[10] DOI: 10.2514/3.11817 · Zbl 0785.76069 · doi:10.2514/3.11817
[11] DOI: 10.1017/S0022112002003440 · Zbl 1141.76304 · doi:10.1017/S0022112002003440
[12] DOI: 10.2514/2.1382 · doi:10.2514/2.1382
[13] DOI: 10.2514/1.40811 · doi:10.2514/1.40811
[14] DOI: 10.2514/3.48982 · doi:10.2514/3.48982
[15] DOI: 10.1007/s001620100038 · Zbl 1046.76016 · doi:10.1007/s001620100038
[16] DOI: 10.1146/annurev-fluid-122109-160750 · Zbl 1299.76054 · doi:10.1146/annurev-fluid-122109-160750
[17] J. Fluid Mech. 599 pp 309– (2008)
[18] DOI: 10.2514/1.43388 · doi:10.2514/1.43388
[19] DOI: 10.2514/2.1671 · doi:10.2514/2.1671
[20] DOI: 10.1016/0021-9991(92)90046-2 · Zbl 0766.76084 · doi:10.1016/0021-9991(92)90046-2
[21] DOI: 10.1121/1.1893428 · doi:10.1121/1.1893428
This reference list is based on information provided by the publisher or from digital mathematics libraries. Its items are heuristically matched to zbMATH identifiers and may contain data conversion errors. In some cases that data have been complemented/enhanced by data from zbMATH Open. This attempts to reflect the references listed in the original paper as accurately as possible without claiming completeness or a perfect matching.